FT-14L

Replacement Front Main Harness for Drop Deck and Some Deck Over Trailers 82" Long Plugs into Existing Harness on Trailers Built After April 2008 T...

Inner Bearing fits 25520 Race (Sold Separately) Fits most 6-8K axles as an inner bearing Also fits a 9-10k general duty axle outer bearing Inside ...

Kit Includes: Battery Battery Box Breakaway Switch Pin/Cable Instructions Hopkins Engager System.  Brakes Activate Upon Separation From Tow Vehi...

This is a complete wiring Harness for a 14'-20' Electric Brake Drop Deck Trailer. Plug-in Installation Can run Dual Tail Lights Pre-Run Red Wire f...

2.5" LED AMBER MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050026    

2-1/2" Round Grommet - Flush Mount - Open Back

2.5" LED RED MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050027

12K side wind front pin jack with welded 4 bolt plate   

Dexter Double Lip Grease Seal 6-7K axle, can be used in a 8K Grease Hub as well. Inside Diameter = 2.25" Outside Diameter = 3.376"  Double Lip w/ ...

0.75" AMBER BULLET LIGHT WITH GROMMET PREVIOUSLY WAS PART #1050028

Left Hand Tail light box assembly Takes one 4" round tail light and two 2 1/2" red clearance lights. Lights are not included.

3/4" RED BULLET LIGHT WITH GROMMET PREVIOUSLY WAS PART #1050035

3.265" Outside Diameter  Matching Bearing 25580 (Sold Separately) Fits most 6-8K axles with 8 bolt hub/drum Also fits 10 General duty as a outside...

Solid molded construction of lens and housing creates superior durability and impact resistance

Replacement Trailer Hub Bearing  Inside Diameter of 1.25" Outer Bearing for 5K-7K 8 Lug Hub Trailers Works with Race # 14276 (Sold Separately)

1/2" X 2.5" long, Standard on a 6-7k Axle Drum Thread Diameter: 1/2" Stud Length: 2-1/2" Spline Length: 0.68" Base Length: 1.38" Spline Diameter: ...

Left Hand Tail Light box assembly, Please look at the options for light boxes. Make sure this is the one you need by looking at the print. Protect ...

Replaces the switch that came with your trailer break away kit. Kit Includes: Cable and pull pin Weldable, high-temp metal mounting tab Silver con...

EZ Lube Rubber Plug Fits all EZ Lube Caps Fits into Center Hole with Diameter of 1-3/16"

Master Cylinder Kit Kit Includes Mounting Hardware, Gasket, Cap, Rubber Boot, and Cover Plate Mounting Hole Dimensions 2"x3" Diaphragm in Master C...

Dexter Trailer Hub and Drum Assembly - 5,200-lb to 7,000-lb E-Z Lube Axles - 12" - 8 on 6-1/2 3.5K lbs Capacity 8 on 6.5" Bolt Pattern For Use wit...

Master Cylinder Fill Cap Includes Built In Diaphragm Includes O-Ring Fits All Models Shown In Diagram (17) 

14276 Replacement Race 2.717" Outside Diameter Matching Bearing 14125A (Sold Separately) Fits 6K & 7K Axle Capacity Trailers with 8 Bolt Hub

Abs Malfunction Light, 2 1/2" Clearance & Side Marker Light - Amber W/Abs Mark.