FT-20 I-S

Replacement Front Main Harness for Drop Deck and Some Deck Over Trailers 82" Long Plugs into Existing Harness on Trailers Built After April 2008 T...

7K Jack, Top Wind with 4 Bolt Plate, Painted Black

2001858 Hydraulic Cushion Cylinder for Drop Deck Tilt Trailers Interior port to slow Back and Forth fluid flow Filled with Automatic Trans Fluid 2...

Drop Deck Trailer 12K Jack, Side Pin Side Wind, With Plate for use with DDI and IT-I trailers. 

25K Jost Drop Foot 2 Speed Jack with Plate welded on

Inner Bearing fits 25520 Race (Sold Separately) Fits most 6-8K axles as an inner bearing Also fits a 9-10k general duty axle outer bearing Inside ...

2.5" LED AMBER MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050026    

Kit Includes: Battery Battery Box Breakaway Switch Pin/Cable Instructions Hopkins Engager System.  Brakes Activate Upon Separation From Tow Vehi...

This is a complete wiring Harness for a 16' Electric Brake Drop Deck Trailer. Plug-in Installation Can run Dual Tail Lights Pre-Run Red Wire for S...

7-9K Dexter Axle Oil Cap, O-Ring, and Plug Kit   Formerly part number RG04-230

5 Leaf Slipper Spring Number of Leaves: 5 26-1/8" Length (From Center Eye to End of Slipper) 2" Wide 9/16" Eye Diameter Nylon Bushing 3.5K Capacit...

2-1/2" Round Grommet - Flush Mount - Open Back

Deck-Over Trailer Jack 12K Drop Foot Side Wind Side Pin

This is bare beam only.  Most axles have to be ordered, figure usually about 2.5 weeks depending on order date. These are the most common axles siz...

Dexter Double Lip Grease Seal 6-7K axle, can be used in a 8K Grease Hub as well. Inside Diameter = 2.25" Outside Diameter = 3.376"  Double Lip w/ ...

2.5" LED RED MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050027

12K side wind front pin jack with welded 4 bolt plate   

This is a replacement spring for your FT-15 and FT-16. Mounts to trailer frame with hangers or a hanger kit (sold separately) • Number of Leaves: 7...

Red Oval LED Tail Light Used With Grommet #2008690 (Sold Separately)  Previously Was Part #1050023

This is a replacement spring for your FT-6, FT-10 or FT-12 5 Leaves 26-5/8" Length (from the Center of the Eye to the End of the Slipper) 2" Wide ...

2 5/16" Flat Plate Mount Coupler 4 Bolt mount 21K Does not require a hitch pin

Unitized Oil Seal  2.25" Inside Diameter 3.376" Outside Diameter Fits Select 8K Axles  

0.75" AMBER BULLET LIGHT WITH GROMMET PREVIOUSLY WAS PART #1050028

One piece tandem axle fender, made in-house with 14ga material. These are used on newer Felling Trailer designs and have a butt-welded backer.