Hydraulic Drop-Deck Dump Trailers

Replacement Front Main Harness for Drop Deck and Some Deck Over Trailers 82" Long Plugs into Existing Harness on Trailers Built After April 2008 T...

7K Jack, Top Wind with 4 Bolt Plate, Painted Black

This Pendant is a replacement for Felling Trailers after 2015. It will fit DC4309 Pumps and is for a Power Up and Down Model. This is a 4 Wire Remo...

Inner Bearing fits 25520 Race (Sold Separately) Fits most 6-8K axles as an inner bearing Also fits a 9-10k general duty axle outer bearing Inside ...

Hydraulic reservoir tanks can also be used to reduce and recover hydraulic fluid loss, cool the fluid, reduce air entrenchment in the fluid, and ac...

2.5" LED AMBER MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050026    

7-9K Dexter Axle Oil Cap, O-Ring, and Plug Kit   Formerly part number RG04-230

Dump Trailer Door Hinge w/ Grease Fitting 3-1/2" Hole Centers Bolt-On Mounting

Power steering reservoir O-Ring Fits all standard 3, 6, and 8 quart tanks

Pump Motor Solenoid, KTI Brand Pump DC4309 12v DC 100 AMP 4 Terminal Starter Solenoid Used for Hydraulic Dump Trailers For both Power Up and Power...

5 Leaf Slipper Spring Number of Leaves: 5 26-1/8" Length (From Center Eye to End of Slipper) 2" Wide 9/16" Eye Diameter Nylon Bushing 3.5K Capacit...

2-1/2" Round Grommet - Flush Mount - Open Back

This is bare beam only.  Most axles have to be ordered, figure usually about 2.5 weeks depending on order date. These are the most common axles siz...

Dexter Double Lip Grease Seal 6-7K axle, can be used in a 8K Grease Hub as well. Inside Diameter = 2.25" Outside Diameter = 3.376"  Double Lip w/ ...

2.5" LED RED MARKER LIGHT GROMMET NOT INCLUDED USE GROMMET #2008688 PREVIOUSLY WAS PART #1050027

12K side wind front pin jack with welded 4 bolt plate   

This is a replacement spring for your FT-15 and FT-16. Mounts to trailer frame with hangers or a hanger kit (sold separately) • Number of Leaves: 7...

This is complete replacement pump for a Dump Trailer or a Power Hydraulic Tilt Trailer. 

Red Oval LED Tail Light Used With Grommet #2008690 (Sold Separately)  Previously Was Part #1050023

15' extension replacement for Felling Trailers after 2015. It will fit DC4309 Pumps and is for a Power Up and Down Model. This new option allows yo...

This is a replacement spring for your FT-6, FT-10 or FT-12 5 Leaves 26-5/8" Length (from the Center of the Eye to the End of the Slipper) 2" Wide ...

2 5/16" Flat Plate Mount Coupler 4 Bolt mount 21K Does not require a hitch pin

Unitized Oil Seal  2.25" Inside Diameter 3.376" Outside Diameter Fits Select 8K Axles  

0.75" AMBER BULLET LIGHT WITH GROMMET PREVIOUSLY WAS PART #1050028